Publicité
4.7
Multi-function buttons
ON / OFF
The button has three functions:
LEFT
Press the button for 0.1 second to:
RIGHT
Press the button for 0.1 second to:
ESC
The button has three functions:
In Setup Mode, press and hold the button for 3 seconds to exit the Setup Mode
In Setup Mode, press the button for 0.1 seconds to exit the current setting entry
without confirm the changes
Execute a manual battery test (normal mode)
ENTER
The button has three functions:
To silence an alarm (normal mode)
Press and hold the button for 3 seconds until one beep and the SET icon will
be turned on
In Setup Mode, press the button for 0.1 seconds to:
4.
Turn on the UPS
5.
Turn off the UPS
6.
Fault Clear
When the UPS has a fault condition, press and hold the button for 1
second, release it after one beep, and the UPS will clear the fault
condition
•
Normal mode: go to the previous display
•
Setup mode: decrease a number or change a setting value
•
Normal mode: go to the next display
•
Setup mode: increase a number or change a setting value
4.
Exiting the Setup Mode
5.
Exit setting entry without confirm
6.
Battery Test
4.
Mute button
5.
Enter the Setup Mode
6.
Confirm
•
Enable the editing of the current setting. As confirmation, the value
on the digits will start to flash.
•
Save the changes of the current setting. As confirmation, there is
one beep and the value on the digits stop to flash.
KEOR SPE R/T
Installation and User Manual
56
Publicité
