Publicité
cause kickback. The application
tool becomes blocked when it becomes
jammed in the workpiece or when the
power tool becomes overloaded.
• Always wait until the power
tool has come to a complete
stop before placing it down. The
application tool can jam and cause
you to lose control of the power tool.
• Hold the power tool securely.
When tightening and loosening screws
be prepared for temporarily high
torque reactions.
• Use suitable detectors to de-
termine if there are hidden sup-
ply lines or contact the local util-
ity company for assistance. Con-
tact with electric cables can cause fire
and electric shock. Damaging gas lines
can lead to explosion. Breaking water
pipes causes property damage.
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of hand/arm vibration in the event that
the tool is used over a longer period
of time or is not used and maintained
properly.
• Cutting injuries
WARNING! Danger due to electro-
magnetic field generated while the tool is
in operation. Under certain circumstances,
this field may negatively affect active or
passive medical implants. In order to re-
duce the danger of serious or fatal injur-
ies, we recommend that individuals who
wear medical implants should consult their
doctor and the manufacturer of the im-
plant before operating the machine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• Direction of rotation switch (15)
(Fig. A)
NOTICE! Only operate the direction
of rotation switch when the tool has
stopped!
The arrow on the direction switch (15)
indicates the working direction.
•
Screw in screw, drill
• Centre Switch lock
•
Unscrew screw
• Torque adjustment ring (3)
Setting of the maximum torque for
screwing at which the slipping clutch is
disengaged.
NOTICE! Only operate the torque ad-
justment ring when the device is at a
standstill!
• 1 lowest torque
• 25 highest torque
To be safe, start with a low torque
when screwing. Increase torque ac-
cording to requirement.
•
drilling without torque limit
GB
MT
27
Publicité
