Publicité
B_ Use this hookup if your TV doesn't have stereo jacks
Stereo receiver ©
S-video cable
(supplied)
Audio cable (not supplied)
If your TV has an S-video input connector, you will get a better picture using, the supplied S-video cable.
If your TV doesn't have audio/video (A/V) input jacks, make an
Val <-Talare marere).qele)
antetnna connection using an antenna cable (not supplied).
A Use this hookup if you're using:
e VHF/UHF antenna (you get channels 2-13 and channels 14 and higher)
e UHF-only antenna (you get channels 14 and higher)
e separate VHF and UHF antennas
Rear of TV
VHF/UHF
A
Match the type of connector
on your TV: A, B, or C.
COCTDOONOOIRONOODIOOIONAND
Rear of TV
VHF/UHF
A
Match the type of connector
on your TV: A, B, or C.
eb nwcewawe
For connector types B and C,
no UHF connection is
required.
Note
To view the
pl
ictur
r
his hook
Sie ea
eee
o
view
the playback picture through this
hookup
monaural even when you
Set the RF UNIT switch to CH 3 (channel 3) or CH 4 (channel 4),
Play back a stereo tape.
whichever channel is not used in your area. If both are used, set the
switch to either channel.
If you made A/V connections (from page 8), you can skip this step.
Getting Started
Q-EN
Publicité
