Publicité
Step 3: Hookups
Caution
=
Connections between the
VCR's VHF/UHF connector
and the antenna terminals of
the TV receiver should be
made only as shown in the
following instructions. Failure
to do so may result in
operation that violates the
regulations of the Federal
Communications Commission
regarding the use and
operation of RF devices. Never
connect the output of the VCR
to an antenna or make
simultaneous (parallel)
antenna and VCR connections
at the antenna terminals of
your receiver.
PASTo[ToyAVilo (tem e-VATA Mateo) .qule)
Before you can use your VCR for the first time, you need to connect it to
your TV. This section explains how to hook up and set up your VCR so
that you can start enjoying it right away.
Note to CATV system installer
Before you get started
¢ Turn off the power to all equipment.
¢ Do not connect the AC power cord until all of the connections are
completed.
~
¢ Be sure you make connections firmly. Loose connections may cause
picture distortion.
° If your TV doesn't match any of the example provided, see your
nearest Sony dealer or qualified personnel.
If your TV has audio/video (A/V) input jacks, you will get a better
picture and sound if you hook up your VCR using these connections. In
addition, for a true "home theater" experience, you should connect the
audio outputs of your VCR or TV to your stereo system. If your TV
doesn't have A/V
inputs, see the following pages for antenna hookup.
A_
Use this hookup if your TV has stereo jacks
R-AUDIO-L VIDEQ S VIDEO
LINE OUT
"SVideo cable
(supplied)
Audio/video cable (supplied)
'eoodcondcondoCNNcoNooeNNCOD
x
ag
ee
mmm
4s
Stereo receiver.
8-EN
Getting Started
Publicité
