Publicité
n If the product is not configured for the
"Solar charging" and "Solar-assisted
charging" charging modes, the buttons
have no function.
For the 22 kW variants and the 11 kW vari-
ants with activated dynamic phase
changeover, the following applies:
n It is possible to switch between the "Fast
charging", "Solar charging" and "Solar-
assisted charging" modes at any time
(even during active charging).
For the 11 kW variants with deactivated dy-
namic phase changeover, the following ap-
plies:
n It is possible to switch between the "Fast
charging", "Solar charging" and "Solar-
assisted charging" modes at any time
(even during active charging).
n It is not possible to switch between the
"Fast charging" and "Solar charging" or
"Solar-assisted charging" charging
modes during an active charge. The
vehicle must be disconnected from the
charging station before switchover.
Charging process does not start
If the charging process does not start, the commu-
nication between the charging point and the
vehicle may be faulty, for example.
u Check the charging plug and the charging
socket for foreign objects and remove if neces-
sary.
u Have the charging cable replaced by a qualified
electrician if necessary.
Ending the charging process
ATTENTION
Material damage due to tensile stress
Tensile stress on the cable may cause cable breaks
and other damage.
u Grasp the charging cable at the charging plug,
and pull it out of the charging socket.
u End the charging process on the vehicle or by
holding the RFID card in front of the RFID card
reader.
u Grasp the charging cable at the charging plug,
and pull it out of the charging socket.
u Put the protective cap on the charging plug.
u Hang the charging cable kink-free.
EN
39
Publicité
