Miele PDR 910 G Plan D'installation page 5

Tip: We recommend connecting the tumble dryer to the power supply via a plug and socket
so that it is easier to conduct electrical safety checks (e.g., during maintenance or repair
work).
The tumble dryer must not be connected to devices such as timers which would switch

it off automatically.
If local regulations require that a residual current device (GFCI) is installed, a type B
residual current device (sensitive to universal current) must be used.
After installing the tumble dryer, equipotential bonding must be established. The equipo-

tential bonding must comply with the local and national installation specifications.
Gas
Connection and conversion instructions
 Danger caused by improper gas connection.
There is a risk of serious damage, injury, or even death if installation work is carried out in-
correctly.
Gas connection and conversion work must be performed by Miele Service or by an au-
thorized dealer.
The shut-off equipment and connection hose for the gas connection must be installed by
the customer on site.
A suitable connection hose can be purchased from Miele as an optional accessory.
The gas machine must be connected using a corrugated metal hose assembly made from
stainless steel in accordance with DIN 3384. Alternatively, a hose that complies with
DIN EN 16617 may be used with connections in accordance with DIN 3384.
The maximum length of the hose is 6' 6" (2 m). When selecting a hose, the required flow
rate and applicable national regulations must also be taken into account.
Initial connection
The initial connection must be carried out by a licensed specialist company according to
specific national regulations.
 The configuration ex works must allow the tumble dryer to be operated with the rele-
vant gas type, gas group, and connection pressure.
This tumble dryer is configured ex works for operation with Natural (Gas A) and Propane
(Gas E).
The data plate provides information about the gas inlet pressure and the corresponding jet
pressure. Compare the specifications on the data plate with those of the gas network oper-
ator.
The required gas valve settings are described in the accompanying setting and conversion
instructions.
Converting to another gas type
 Danger if conversion work is not performed correctly.
Conversion work on the tumble dryer should be performed by authorized specialists only.
If the tumble dryer is to be converted to a gas type other than the one specified on the
data plate, refer to the accompanying setting and conversion instructions.
en - Installation notes
5