Miele PDR 910 G Plan D'installation page 13

– den Adapter (liegt bei).
ei).
– Alu-Flex Abluftschlauch (nachkauf-
bares Zubehör).
aus
ge Ma-
bestän-
det
Install the adapter (1) and the flexible aluminum exhaust air hose (2).

^ Installieren Sie den Adapter (1) und

den Alu-Flex Abluftschlauch (2).
Wrap heat-resistant metallic tape around plug connections.
,
Steckstellen müssen mit wärme-
Shared exhaust air duct
festen Metallklebeband umwickelt
A shared exhaust air duct is only permitted in exceptional cases. The shared exhaust air
werden.
duct must be approved by the relevant building inspector.
stutzen
 A non-return flap must be installed for each tumble dryer.
,
Otherwise, the tumble dryers may be damaged by a backflow of condensation and their
Sichern Sie den Trockner mit
ärme-
electrical safety could be affected.
Spannlaschen gegen Verrutschen.
If 3–5 tumble dryers are installed on one shared exhaust air duct, the pipe diameter D must be in-
creased.
Number of tumble dryers
mit
3
4–5
en - Installation notes
Factor for increasing the pipe diameters from Ta-
ble II
1.25
1.5
13