Publicité
FR
6. USE
ES
• Hold the product with one hand on the main handle and with the other hand on gripping
surface.
PT
• Hold the product with one hand on the main handle and with the other hand on the rear handle
when the extension shaft is assembled.
IT
• Switch the product ON by pressing the trigger and wait until it runs at full speed before placing
it on the work surface.
• To switch OFF the product, just release the trigger
EL
• To lock the product on ON mode, press the orange button located above the trigger when the
product is running.
PL
• To increase the rotate speed, press the + button located on the main handle. To decrease the
rotate speed, press the - button located on the main handle.
UA
• Keep the base plate as parallel to the work surface as possible.
• Ensure that the machine head is in contact with the work surface.
RO
• Move the product back and forth with slow even speed.
• Only apply as much pressure as necessary to keep the product at on the work surface. Higher
pressure will not increase but lower the performance of the product and leads to uneven results.
EN
• Keep the product moving at all times, do not stop in one position to avoid grooves.
• Lift the product from the work surface before switching it off.
190
190
Publicité
