Publicité
5. BEFORE USE
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
NOTE: Prior to assembly and adjustment always unplug the tool.
• Fully unfold the upper shaft in the direction against the lower shaft.
• Secure the connection with the locking device.
• Use the extension shaft according to the intended operation for higher work surface.
• Loosen the sleeve on the dust extraction outlet of the upper extension shaft. Do not remove the
sleeve from the outlet.
• Align the rear handle with the main handle and insert the sleeve on the extension shaft into the
outlet with a twist motion all the way to the stop.
• Adjust the length of the extension shaft if necessary. Pay attention to the marking «Max 1.65m»
on the extension shaft. Tighten the sleeve after assembling/adjusting the extension shaft.
• Align the hole pattern of the sanding paper with the one in the base plate before attaching the
sanding paper to the plate to ensure efficient dust extraction and a satisfactory result.
• Slightly press the sanding paper to fix it to the base plate.
• Insert the vacuum hose connector into the dust extraction outlet all the way to stop.
• Secure the connection by tightening the sleeve on the outlet afterward.
• Attach a dust extraction device e.g. a suitable vacuum cleaner to the vacuum adaptor. Loosen the
sleeve on the dust extraction outlet, hold the handles and pull the connector out of the outlet to
remove the vacuum hose from the product.
• Ensure the work surface is free of obstacles like nails or screws before operation. Remove them
if required.
ASSEMBLY AND ADJUSTMENT
FR
ES
PT
IT
EL
PL
UA
RO
EN
189
189
Publicité
