Machine Operation; Lowering The Floor Tool; Raise / Lower Brush Deck; Setting The Cleaning Controls - Numatic TGB 8572/200T Notice Originale

Raising/Lowering
the Floor Tool
After preparing the floor (see previous
section), we are now ready to set the
controls to suit the cleaning conditions.
Before any settings can be applied,
ensure the brush deck is lowered. Move
the floor tool lever to its lower position.
NOTE: Do not drive the machine
backwards with the floor tool in the
lowered position, this could possibly
damage the blades.
Raising/Lowering the Brush Deck
The control for lowering the brush deck can be found to the rear right of the machine.
Lower the brush deck by moving the left hand release lever to the upper position.
D

Setting the Cleaning Controls

Insert the key, turn the main control on / off key to position '1'.
B
(Fig.A) The traction status light will illuminate.
Set desired traction speed as required, depending on floor type
and level of soiling (Fig.B).
Middle speed is the optimum cleaning speed.
A
Set the flow rate (Fig.C).
The TGB 8572/200T is equipped with an electronic braking
system.
Simply release the hand operated start / stop trigger and the
machine will stop.
In an emergency, strike the Emergency Stop button. (Fig.D).
The machine will be disabled.
C
To reset, turn Emergency Stop button clockwise.
After re-setting the Emergency Stop button, to restart the
machine, turn the main control on / off key to '0' and then
position '1'.

Machine Operation

T 01460 68600
15