Machine Set Up Guide - Numatic TGB 8572/200T Notice Originale

!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
TGB 8572/200T
CONTENTS
● 2 x Ignition Keys ● 2 x 40 Amp Fuse
(Battery) ● 1 x 30 Amp Fuse (Brush)
● 1 x 20 Amp Fuse (Vac)
● 1 x 2.5 Amp Fuse ● Maxi Fuse-puller
Lift top tank assembly to reveal battery
compartment, ensuring you use the handle
grip provided.
Fit battery fuses (contained in start-up
pack) into the battery fuse holders as
illustrated.
(Fig. 1, 2, 3.)
Insert Key into ignition located on the
control panel (See below (Fig. A)
NOTE: Wear suitable gloves when
inserting fuses.
1
Less Battery Models - Numatic International Ltd recommends using MK Batteries for the 8572/200T in the TGB machine mentioned
in this manual. For full battery spscifications see page 48.
!
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
WHEN INSERTING THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
2
WHILE THE BATTERIES ARE EXPOSED.
Insert the Ignition key and
A
switch the machine on.
(Fig. A)
Depress control handle with both hands (Fig.B)
When the machine is removed and in a safe position,
Note: During vehicular transportation ensure
the product is secured to avoid unnecessary
Use handle grip when
raising or lowering the
top waste-tank.
and slowly drive machine off of the pallet.
turn key back to the position (0) 'OFF'
Machine Set-up Guide
3
B
movement.
T 01460 68600
!
Fuse Location
!
7