Machine Operation; Raising/Lowering Floor Tool; Machine In Use - Numatic HTB 1840 Notice Originale

Machine Operation

Raising/Lowering
the Floor Tool
To raise the floor-tool, ensure the floor-tool
carrier is central to the machine.
Lift the lever near the base of the handle
and lock into position.
A
!
Always ensure that chemical manufacturer's safety guidelines are followed.
!
Do not operate machine unless the Operator Manual has been

Machine In Use

To operate, set water flow rate tap, lower the floor tool, press the vacuum / water switches, pull brush
On/Off trigger.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed (2%), when full.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor tool in the raised position,
allow the chemical time to work then scrub the area a second
time with the floor tool lowered.
If streaking occurs wipe floor tool blades clean.
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles
15
www.numatic.co.uk
B
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
IMPORTANT
read and fully understood.
Emptying Top Tank
After use, empty waste-water tank using
emptying hose and flush-out with clean
water. (fig.A).
Emptying Bottom Tank
The clean-water tank can be drained via
the yellow cap fitted to the left hand side
of the machine. There is a sealing bung
beneath the yellow cap (ensure the sealing
bung is clean) The cap should only be done
up by hand. (fig.B).
!
!