Frequently asked questions
Time lag
When travelling in Europe: If you are at the start of your cycle,
communicate the start of your cycle to the cyclotest® 2 plus with the
small round button on the 1st day of your period and take a break
from measuring until you have reached your destination and have
acclimatised. Then resume measuring as normal. To ensure that the
prognoses remain accurate, however, you should start the measure-
ments no later than on the 5th cycle day.
When travelling outside Europe:
The time differences on long-haul journeys are for the most part so
great that your wake-up time is outside the "time window" in which
cyclotest® 2 plus accepts your measurement. In such cases please
contact the cyclotest® service hotline in good time.
Turn off wake-up alarm
If you do not want to be disturbed, e.g. you want to have a lie-in at the
weekend, you can turn off the wake-up alarm. To do so, press the large
round Measurement button once briefly when the unit is switched off.
You will see the following display:
Again press the large round Measurement button once briefly.
To turn the wake-up alarm back on, proceed as described above. The
unit confirms the input with a beep.
EN-74
Fig. no. 26
Wake-up alarm on (more bars)
Fig. no. 27
Wake-up alarm off (fewer bars)
Frequently asked questions
Measurement button pressed without sensor at point
of measurement
cyclotest® 2 plus breaks off the measurement and signals this acousti-
cally with three beeps and optically with an "E". See Fig. no. 13.
Start of cycle input incorrectly
If you have accidentally entered the start of your cycle incorrectly, call
our service hotline. Keep your device to hand for this call.
Pregnancy display
cyclotest® 2 plus is waiting for your cycle start. In this case, there are
two possibilities:
1) You have forgotten to start a new cycle on the first day of
menstruation.
2) If there is no menstruation, you may be pregnant.
Important: If within a cycle you observe inexplicable temperature re-
sponses which deviate from your previous cycles, call the cyclotest®
service hotline.
.........................
.... Ich bin mir sicher.
Fig. no. 28
EN-75