Fever And High Temperature; Measurement Button Pressed Without Sensor At Point Of Measurement; Irregular Cycle; Time Lag - uebe cyclotest baby Mode D'emploi

Frequently asked questions

Fever and high temperature

An atypical increase in temperature is blanked out during the cycle re-
cording. If there are not enough temperature values that can be eval-
uated during a cycle, the fertile phase is extended. See Fig. no. 11 "H".
Measurement button pressed without sensor at point
of measurement
cyclotest® baby breaks off the measurement and signals this acousti-
cally with three beeps and optically with an "E". See Fig. no. 13.

Irregular cycle

The unit displays a cycle length of 32 days in the bar chart. Counting
is continued automatically for longer cycles.
In the event of irregular cycle lengths, a longer fertile phase is dis-
played.

Time lag

When travelling in Europe: If you are at the start of your cycle, commu-
nicate the start of your cycle to the cyclotest® baby with the small round
button on the 1st day of your period and take a break from measuring
until you have reached your destination and have acclimatised. Then
resume measuring as normal. To ensure that the prognoses remain ac-
curate, however, you should start the measurements no later than on the
5th cycle day.
EN-73
Fig. no. 29
You can recognise this by the flashing square
in the bar chart, by the small arrow under-
neath and by the digit at top left.