Operating the unit
Recall of cycle summaries for previous cycles (unit is switched off
or on the current cycle day):
1. Briefly press the right Arrow button twice. The following appears:
This is how you read the overview:
• The digits on the left and right refer to the flashing cycle.
• Left digit: day of CY input if corresponding information was input
• Right digit: day of temperature high if a temperature high was de-
tected
Press and hold down the large Measurement button: the temperature
high is replaced by a display of the cycle length.
Press the left or right Arrow button. The flashing bar in the bar chart
moves and shows you which cycle you are in at the moment (right:
current cycle, left = oldest stored cycle). 12 cycles can be stored.
EN-70
Fig. no. 23
First bar from the right shows the current
cycle
Fig. no. 24
Operating the unit
Fertility profile
Where your gynaecologist in the past recommended that you kept a
menstruation calendar, he/she today can analyse your cyclotest® 2
plus fertility profile.
Your cyclotest® 2 plus offers you this service:
• Display of all the information stored in the unit
• Evaluation of the data on a PC
Evaluation of the data on a PC
To ensure communication between cyclotest® 2 plus and your PC, you
will need the cyclotest® control software. This software contains the
drivers for the USB port and the cyclotest® program for evaluating the
stored data. The cyclotest® control software with USB connecting cable
is available as an accessory from all good pharmacies. Art. no. 065501,
PZN 05103265.
With the integrated USB port and additional software it is possible to
read out the data of the current cycle from the unit and create your
fertility profile as a PDF document.
Note: Once you have input a new cycle start, you can no longer dis-
play a temperature curve from the previous cycle. The data from the
previous cycles are listed in table form below the current temperature
curve.
.........................
.... Ich bin mir sicher.
EN-71