uebe cyclotest 2 plus Mode D'emploi page 30

Operating the unit
2. Unwinding the sensor cable:
The sensor is located at the top in the sen-
sor compartment. Pull the round cable reel
on the back of the unit to extend the length
of the cable sensor as required by uncoiling.
This enables you to take your measurement
comfortably while lying down. Then close
the reel again.
3. Selecting the measurement location:
You can take the measurement orally, rectal-
ly or vaginally, but you should then stick to
the point of measurement you have chosen.
Measuring under the arm (axillary) produces
inaccurate results. It is therefore unsuitable
for recording the basal temperature.
4. Measurement process:
We recommend that you take the measurement under your tongue
with your mouth closed. Place the sensor tip in one of the two heat
pockets under your tongue to the left or right of the root of the tongue.
The sensor must make good contact with the tissue. Close your mouth
and breathe easily through your nose so that the measurement result
is not compromised by inhaled air.
EN-58
Operating the unit
5. Starting the measurement:
6. End of measurement:
The unit confirms successful measurement (duration of measure-
ment approx. 60-90 seconds) with a long beep and indicates the
measured temperature in the display at top right. The unit switches
off automatically after approx. 1 minute.
If you break off the measurement too early, the unit will alert you
with 3 short beeps that it was unable to store a measurement result
because the warm-up phase was not completed. In this case, please
measure again and remove the sensor only when you have heard a
long beep. cyclotest® 2 plus takes care of everything else in the back-
ground.
Your measured value has been automatically stored.
Once you have taken the measurement, cyclotest® 2 plus indicates
your fertility status for the current day.
......................... .... Ich bin mir sicher.
When the sensor tip is resting steadily and
comfortably, press the large red Measure-
ment button briefly.
Please be patient during the measurement.
The sensor must warm up first (from room
temperature to body temperature).
EN-59