Cycle Start Input Forgotten; Important; How To Measure Your Wake-Up Temperature - uebe cyclotest 2 plus Mode D'emploi

Operating the unit

Cycle start input forgotten

Press the small round Cycle Start button again firmly and for a sustained
period. At the same time press the right Arrow button repeatedly until
your current cycle day appears in the display (e.g. 02). Keep the Start
button pressed until the input is confirmed with a beep. Your display
should now look like this:

Important:

After a new cycle start you can no longer print out the last
fertility profile. See Page 71.
EN-56
Fig. no. 3
Operating the unit
2

How to measure your wake-up temperature

Once the cycle start has been successfully input, you can take your
temperature measurements. Begin the morning after before getting
up. Select the time of your first measurement to correspond to your
daily routine.
1. Determining the measurement period:
cyclotest® 2 plus has a measurement window of four hours. With the
first measurement on the morning after you inputted the start of your
cycle, the measurement period of +/- 2 hours is automatically deter-
mined for the current cycle. If, for example, you took a measurement
at 7.00 a.m., the next morning six short beeps will remind you to take
a measurement at this time (also see page 61). For this cycle, you can
take measurements from 5.00 a.m. to 9.00 a.m.
Note:
- Measurements taken as close as possible to the same time period
optimise the evaluation.
- You have to get at least five hours of sleep before taking a
measurement.
- You must take the measurement before getting up.
......................... .... Ich bin mir sicher.
EN-57