Alarm Function - uebe cyclotest 2 plus Mode D'emploi

Masquer les pouces Voir aussi pour cyclotest 2 plus:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating the unit
6. Measured value is saved:
If you measure outside these four hours, the measurement is not
stored and the following display appears:
Further information from the second cycle
Proceed as in the first cycle when inputting a new cycle start and
during the measurements.
As from the second cycle start cyclotest® 2 plus has "learned" a few
things using your inputs and measurements in relation to the first
cycle.
The expected end of the fertile phase in the current cycle is indicated
– similarly to the previous cycle – in the display on the time axis.
EN-60
infertile
Fig. no. 12 no "babies" mean
phase
.
Fig. no. 14 Alternately flashing "babies"
"fertile phase"
mean
.
Fig. no. 4
Fig. no. 6
A display looks like this after the start of the
2nd cycle
Operating the unit
The expected infertile phase after ovulation begins in this example on
the 18th cycle day: the bar chart for the time axis begins at 18.
cyclotest® 2 plus can now display the highly fertile phase (2 permanent
babies). In this phase, we recommend in addition to interpreting the
temperature responses that you observe and input body symptoms.
(See Page 68)

Alarm function

Attention: Select the time of your first measurement to correspond
to your daily routine.
cyclotest® 2 plus has a measurement window of four hours. With the
first measurement on the morning after you inputted the start of your
cycle, the measurement period of +/- 2 hours is automatically deter-
mined for the current cycle. The time of your first measurement re-
mains stored in cyclotest® 2 plus for all further measurements during
a cycle. If, for example, you measured at 7 o'clock in the morning, you
will be reminded of this the next morning with six short beeps.
If you did not hear the first wake-up sound, you will be reminded after
10 and again after 30 minutes.
Note:
During your infertile phase following ovulation, you no longer
receive any measurement reminders. No further measurements are
required until you start your next cycle.
.........................
.... Ich bin mir sicher.
Fig. no. 15 "Babies": Two "babies" at the
same time mean "highly fertile phase" (indi-
cation from the second cycle only).
EN-61

Publicité

Table des Matières
loading

Table des Matières