Important Advice For Users - uebe cyclotest 2 plus Mode D'emploi

Safety instructions

Important advice for users

• Check that the sensor is undamaged prior to measurement.
pending on where you use the sensor for measurement, a damaged
sensor could cause unintentional injury.
• It is essential to ensure correct functioning of cyclotest® 2 plus that
you perform the morning measurements of wake-up temperature
before getting up. You should have
in the last hour prior to measurement you should not have got up.
• While cyclotest® 2 plus still "knows" too little about you, i.e. has
still not stored a sufficient amount of cycle values,
phase
will be displayed for your assurance. The fertile phase
to ovulation
can be pinpointed more precisely only when at least
six cycles have been stored.
disturbance factors
• Please note that possible
tomed drinking of alcohol, exceptional stress and a change in en-
vironment can, in individual cases,
may be advisable to omit measurement in such cases. See Page 73.
• If you discover that you have an
due to illness, we advise not taking any further measurements until
you feel better.
After breastfeeding,
• you should only start taking measurements
once you are menstruating regularly again.
EN-48
De-
slept for at least 5 hours
and
a longer fertile
prior
such as unaccus-
influence the temperature. It
unusual increase in temperature
Safety instructions
• This contraception method
infectious diseases.
does not actively intervene in your
• The device
uates temperature parameters and indicates your current status in
the cycle.
• Do not leave the unit unsupervised in the hands of children. It con-
tains small parts that could be swallowed.
tion
by the sensor cable.
......................... .... Ich bin mir sicher.
does not provide protection against
cycle; it only eval-
Danger of strangula-
EN-49