Check Displays - uebe cyclotest 2 plus Mode D'emploi

Operating the unit

Check displays

Note: The displays on the following pages are to be viewed as display
examples.
EN-64
Fig. no. 7
The unit performs a function test after the
Measurement button is pressed, all the dis-
play elements are shown.
Fig. no. 8
DAY NEW: You are in your current cycle.
Fig. no. 9
DAY OLD: When scrolling back, you have
called up the measurement result of the
27th day of your previous cycle. Your current
cycle measurement is not impaired by this.
Fig. no. 10
L (Low): Indicates that your wake-up tem-
perature is below the measurement range of
cyclotest® 2 plus. A flashing "L" during the
measurement indicates that the sensor is
in its warm-up phase. See failure and error
messages Page 78.
Fig. no. 11
H (High): Indicates that your wake-up tem-
perature is unusually high (e.g. fever). See
failure and error messages Page 78.
Operating the unit
Fig. no. 17
"Battery": These displays appear during the measurement or when the data
are called up if the battery power is low and the battery has to be replaced by
UEBE Customer Service. See battery display / battery replacement Page 72.
......................... .... Ich bin mir sicher.
Fig. no. 12
10th cycle day, no "babies" mean infertile
phase.
Fig. no. 13
E (Error): Repeat the measurement if this
letter is displayed. See failure and error
messages Page 78.
Fig. no. 14
"Baby": Alternately flashing "babies" mean
"fertile phase".
Fig. no. 15
"Babies": Two "babies" simultaneously
mean "highly fertile phase". (display only
from the second cycle).
Fig. no. 16
°C: Indicates the measured wake-up tem-
perature accurately in degress Celsius to 2
decimal places.
Fig. no. 18
Fig. no. 30
"Arrow": indicates that your temperature is
still increasing during the measurement.
EN-65