Cycle Start Input Forgotten; How To Measure Your Wake-Up Temperature - uebe cyclotest baby Mode D'emploi

Operating the unit

Cycle start input forgotten

Press the small round Cycle Start button again firmly and for a sus-
tained period. At the same time press the right Arrow button repeat-
edly until your current cycle day appears in the display (e.g. 02). Keep
the Start button pressed until the input is confirmed with a beep. Your
display should now look like this:
Important: After a new cycle start you can no longer print out the
last fertility profile. See Page 63.

How to measure your wake-up temperature

Once the cycle start has been successfully input, you can take your
temperature measurements. Begin the morning after before getting
up.
Note: At least 5 hours sleep needed prior to measurement. The meas-
urement must be taken before you get up.
The sensor is located at the top in the sensor compartment. Pull the
round cable reel on the back of the unit to extend the length of the
cable sensor as required by uncoiling. This enables you to take your
measurement comfortably while lying down. Then close the reel again.
You can take the measurement orally, rectally or vaginally, but you
should then stick to the point of measurement you have chosen.
EN-51
Fig. no. 3