Publicité
3. FUNCTION DESCRIPTION
Preparation
Local Network Connections
The JVRCM270 uses a switch to connect to the local area network. The IP addresses of the
computer or other similar equipment and that of the JVRCM270 must be located in the same subnet
segment.
IP Settings
By default, the IP address of the JVRCM270 is 192.168.100.40 and the subnet mask is 255.255.255.0.
For the IP address of a computer or other similar equipment, you need to manually configure the static
IP address that must be on the 192.168.100 segment with 255.255.255.0 as the subnet mask. If the
computer only connects to the JVRCM270 then this is implemented using a single IP address. If the
computer also connects to the local networks in addition to the JVRCM270 network, then you will need
multiple IP addresses. The following figure shows the implementation method (Windows 7 system is
taken as an example).
- Configure single IP address
Open the Internet Protocol TCP/IP Properties page to configure the IP address and subnet mask. For
example, set the IP address to 192.168.100.44 and the subnet mask to 255.255.255.0.
Click "OK" when the configuration is done.
- Add multiple IP addresses
You need to first configure a static IP address before you can add multiple IP addresses. The steps to
configure the static IP address are as follows:
1) Check local IP address
Open the Internet Protocol TCP/IP Properties page as shown in Figure 2.2. If the option "Use the
following IP address:" is selected and there is an IP address listed here, it indicates that the local IP
address is a static IP address. Otherwise, it is a dynamic IP address and you need to configure a
static IP address.
2) Configure static IP address
Open the Run Command box from the Start Menu as shown in the following figure:
9
V.1
Publicité
