Publicité
Do not use any abrasive cleaning products and nev-
er submerge the device in water.
Important
• Ensure that no water gets inside the device.
• Do not clean the device or accessories in the
dishwasher.
• Do not touch the device with wet hands when it
is plugged in and do not allow water to spray on
the device. Only operate the device if it is com-
pletely dry.
• If liquid penetrates the device this could cause
damage to the electrics or other nebuliser parts
and lead to a malfunction.
Condensation, hose care
Condensation may form in the hose depending on
the ambient conditions. It is essential to remove the
moisture to prevent bacterial growth and ensure
proper treatment. To do so, proceed as follows:
• Remove the compressed air hose
atomiser
.
7
• The hose must remain connected to the nebu-
liser
.
5
• Operate the nebuliser until the moisture is re-
moved by the air passing through.
• In the event of heavy contamination, replace the
hose.
Disinfection
Please carefully observe the points below when
disinfecting your atomiser and accessories. We rec-
ommend disinfecting the individual parts on a daily
basis after the last usage as a minimum measure.
(All you need for this is a little white vinegar and dis-
tilled water.)
• First, clean the atomiser and accessories as de-
scribed in the "Cleaning" section.
• Place the disassembled atomiser, mouthpiece
and nosepiece in boiling water for 5 minutes.
• For the remaining accessories, use a vinegar
solution consisting of ¼ vinegar and ¾ distilled
water. Make sure that the volume is su cient to
fully submerse the parts, such as the atomiser,
mask and mouthpiece, in the solution.
• Leave the parts in the vinegar solution for 30
minutes.
• Rinse the parts with water and dry them carefully
with a soft cloth.
Important
Do not boil or autoclave the compressed air hose
or the masks.
• Put the parts together again when they are com-
pletely dry and place them in a dry, sealed con-
tainer.
Note
• Please ensure that the parts are completely
dried after cleaning, otherwise the risk of bacte-
rial growth is increased.
• Use cold disinfection solution in accordance
with the manufacturer's instructions.
from the
6
Drying
• Place the individual parts on a clean, dry and
absorbent surface and leave them to dry com-
pletely (at least 4 hours).
Durability of materials
• As with any plastic parts, atomisers and their
accessories are a ected by a certain amount of
wear and tear when used and hygienically pre-
pared on a frequent basis. Over time, this can
lead to a change in the aerosol, which can have
a negative e ect on the e ciency of the treat-
ment. We therefore recommend that you replace
the atomiser and other accessories after a year.
• The following point should be observed when
selecting the cleaning product or disinfectant:
only use a mild cleaning product or disinfectant
in the concentration and volume prescribed by
the manufacturer.
23
Publicité
