Publicité
To replace the filter, proceed as follows:
Important
• First switch the device o and disconnect it from
the mains.
• Allow the device to cool down.
1. Pull o the filter cap
Note
If the filter remains in the device after the cap has
been removed, take the filter out of the device, e.g.
with tweezers or similar.
2. Re-insert the filter cap
3. Ensure that it is securely in place.
8. CLEANING AND DISINFEC-
TION
Atomiser and accessories
Warning
Adhere to the following hygiene instructions to avoid
health risks.
• The atomiser
7
for multiple use. Please note that di erent areas
of application involve di erent requirements in
terms of cleaning and hygienic preparation.
Notes:
• Do not clean the atomiser or the accessories
mechanically using a brush or similar device,
as this could cause irreparable damage and it
will mean that the best treatment results can no
longer be guaranteed.
• Please consult your doctor about the additional
requirements in terms of the hygienic prepara-
tion required (hand care, handling of medication/
inhalation solutions) for high-risk groups (e.g.
patients with cystic fibrosis).
• Ensure thorough drying after each cleaning or
disinfection process. Residual moisture or wet-
towards the front.
4
with a new filter.
4
and accessories are designed
ness can represent an increased risk of bacterial
growth.
Preparation
• Immediately after each treatment, all parts of the
atomiser
cleaned of residual medication and contamina-
tion.
D
• Disassemble the nosepiece if you have used it
with the comfort attachment.
• To do this, dismantle the atomiser
dividual parts.
• Remove the mouth piece
the nosepiece
• Dismantle the atomiser
anticlockwise against the medication container
.
8
• Remove the atomiser insert
tion container
• Reassembly is carried out in reverse order.
Cleaning
Important
The device must be switched o , disconnected from
the mains and allowed to cool down each time be-
fore cleaning.
The atomiser and the accessories used such as
the mouthpiece, mask, etc. must be washed with
hot but not boiling water after each use. Dry the parts
carefully using a soft cloth. Put the parts together
again when they are completely dry and place them
in a dry, sealed container or disinfect them.
When cleaning, ensure that any residue is removed.
Never use any substances for cleaning that could
potentially be toxic if they came into contact with the
skin or mucous membranes, or if they were swal-
lowed or inhaled.
Use a soft, dry cloth and non-abrasive cleaning
products to clean the device.
22
C
and the accessories used must be
7
, the mask
10
from the atomiser.
13
by twisting the top
7
9
.
8
into its in-
7
or
11 12
from the medica-
Publicité
