Publicité
EN
Do not tighten all blots and screws before the spit roaster is fully assembled.
Step 3: Put the charcoal tray inside the tub, make sure two handles are attached to the hooks inside
the tub. Put 3 grills on the edge of the stove tub.
Step 4: Put the fork, spine hook and leg shackle on the spit rod, place the spear head into the slot of
the right panel, then put the end of the spit rod into the slot of the left panel which is connected with
the motor. Make sure the motor shaft pin is inserted into the notch on the end of the spit rod. And the
groove on the spit rod must sit on the key stopper (attached to the leg bracket). Adjust cooking height
by move the key stoppers in different slots on the leg bracket.
Publicité
