Publicité
WI-FI FUNCTION
For detailed information on Wi-Fi configuration and on the product registration procedure, refer to the
enclosed Quick Guide dedicated to connectivity, or visit the website
https://discover.ariston-net.remotethermo.com
Description of the water heater connection status
Slow flashing
Quick flashing
Wi-Fi
button
Double flash
On
Off
RESET Wi-Fi: to reset, simultaneously press the "
DIAGNOSTICS
Whenever one of the following faults occurs, the appliance enters the "fault mode" and the status
indicator (Fig. 8, Ref. 1) will be lit red and flashing.
ERROR TABLE
The type of malfunction is indicated on the display, which will show "Er" flashing, alternating with the
relevant error code:
CODE
DESCRIPTION
E01
Memory error (HMI)
E21
Overheating
E22
Thermostat error
E25
Dry heating
E20
Temperature sensor error
E62
Data memory error (HMI)
E60
Wi-Fi error
E61
Board (PCB) error (HMI)
E63
Touch-screen error
E67
HMI-thermostat communication error
E64/E68 GATEWAY error
E65
Meter error
E69
POWERLINE/CHAIN2 error
E71
ENERGY METER installation error
E04
Anode fault
RESET
To reset an error, when possible, run a reset procedure by pressing the ON/OFF button " " to switch the
product off and then on again.
If the cause of the malfunction disappears immediately after the reset, the appliance will resume its
normal operation. If this does not occur and the status indicator is flashing red, contact the Technical
Assistance Centre.
26 / EN
The Wi-Fi module is on
The Wi-Fi module is in Access Point mode
The Wi-Fi module is connecting to the home network
The Wi-Fi is on and connected to the home network
The Wi-Fi module is off
" and "
" buttons for 10 seconds.
ACTION
Run the Reset.
If the error persists, contact the technical assistance
service.
Check for the presence of water and run the reset.
If the error persists, contact the technical assistance
service.
If the error is present, contact the technical assistance
service
Run the reset by disconnecting and reconnecting the
power supply cable.
If the error persists, contact the technical assistance
service.
If the error is present, contact the technical assistance
service
Publicité
