Publicité
Whenever the "ECO" function or the product itself is switched off and then on again, the function will
keep learning the consumption levels. In order to ensure the programme's correct operation, the product
should not be disconnected from the mains electricity. An internal memory ensures that the data will be
stored for a maximum of 4 hours without electricity. After this time, all the acquired data will be deleted
and the learning process will start from the beginning.
To activate the function, press the "ECO" button, which will light up. In this mode, the temperature can
still be selected manually, but adjusting its value will deactivate the ECO function. This function can be
deactivated by pressing the "ECO" button, which will turn off. To reactivate it, press the "ECO" button
again. To voluntarily delete the acquired data, press and hold the "ECO" button for more than 3 seconds.
Once the reset process has been completed, the "ECO" button will flash quickly to confirm the deletion
of the data.
ANTI-FREEZE FUNCTION
The anti-freeze function is an automatic protection for the appliance that prevents damages caused by
excessively low temperatures below 5°C. We recommend leaving the product connected to the mains
electricity, even in case of prolonged inactivity. The function activates automatically when the temperature
drops down to 5°C and deactivates once the temperature rises back up to the protection value. The function
is enabled, but in case of activation it does not indicate whether the product is ON. When the product is
switched off using the ON/OFF button " ", if the anti-freeze function is active the display will show "AF"
(Anti-Freezing).
"THERMAL DISINFECTION CYCLE" FUNCTION (Anti-Legionella function)
The anti-Legionella function is activated by default. It consists of a 1-hour 60°C water heating/maintenance
cycle that performs a thermal disinfection action against the relative bacteria.
The cycle starts when the product is switched on and after a restart following a power outage. If the
product always works at temperatures below 60°C, the cycle is repeated after 30 days.
During the "thermal disinfection cycle", the display will alternately show the water temperature and "Ab".
When the product is turned off, the anti-Legionella function is deactivated. If the appliance is switched
off during the anti-Legionnaire's disease cycle, the product switches off and the function is deactivated.
At the end of each cycle, the operating temperature returns to the value previously set by the user. To
activate this function, simultaneously press and hold the ON/OFF " " and "
" buttons for 3 seconds;
the display will show "A1" for 3 seconds to confirm the activation.
To permanently deactivate the function, repeat the above operation; the display will show "A0" for 3
seconds to confirm the deactivation.
Warning: while the appliance performs the thermal disinfection cycle, the high temperature of the
water may cause burns. Pay attention to the water temperature before taking a bath or shower.
WEEKLY PROGRAMME FUNCTION
The weekly programme function can be activated only through the App.
It is possible to select two different set-point temperatures in two different periods of time for each day
of the week: the product will calculate the heating speed and, on the basis of it, the best time to start
heating so as to satisfy the set-point at the desired time.
If the temperature is modified or the ECO function is activated, the Weekly Programme will be deacti-
vated.
EN / 25
Publicité
