EUROM RK2009N Manuel D'utilisation page 29

Installation, Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.

Screw the 2 x 2 swivel castors (3) with the 4 capped nuts (2) onto the ends of the two
wheel supports (1). The wheels should be at the hollow side!

Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)

Attach the two supports (each with 2 swivel castors) to the radiator. Slide the U-
shaped bolts onto both sides between the outer fins of the radiator, the end the screw
thread and the outwards facing curve.

First slide the supports (with the swivel castors) over the curve and then over the end
of the screw thread.
Please note: the wheels should be placed as far away from one another
as possible!

Return the heater to its upright position, wheels down.
Warning: only use the heater when it is in an upright position, with the wheels attached to
the bottom (as pictured on the front of this booklet). Any other position is dangerous!

Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.

Insert the plug into a suitable and properly functioning earthed wall socket
29