Publicité
3. Preliminary Measures prior to
Starting Up
3.1 Device Installation
Remove all packaging material and all trans-
port bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the fol-
lowing requirements:
The floor should be firm, flat and horizontal.
Minimum distances of 30 cm to the side, 30 cm
to the top, 30 cm to the rear and 1 m to the front
must be maintained from the enclosure.
Do not place the unit in a hot, wet or very humid
environment.
The socket must be easily accessible so that the
mains connection cable can be easily discon-
nected if necessary.
Temperature range: from 0 to +40 °C
Air humidity (no condensation): 5–75 %
4. Starting Up
4.1 Standby mode
Connect the jack plug of the mains cable to
the unit and plug the mains adapter
socket. The unit is now supplied with power. A
short beep sounds.
4.2 Switch on the unit
Note: The buttons have a beep feedback and work
best with a light swipe over them.
Press the key
5 to switch on the product.
The unit starts directly in ventilation level "03"
when it is first put into operation.
10
GB/IE/NI/CY/MT
During further use, the unit starts at the same
ventilation level that was selected during the last
operation.
If the mains adapter
antime, the unit restarts in ventilation level "03".
4.3 Switch off the unit
To return the unit to standby mode after
operation, press the On/Off button
NOTE: The display 1 shows "00" for approx. 10
seconds and then also switches off.
4.4 Select fan speeds
To change the fan speeds, press the button
2 repeatedly until the desired speed (1-10) is
shown on the display 1 .
The desired ventilation level is adopted directly.
4.5 Oscillation function
Press the oscillation key
oscillation of the unit on or off.
The oscillation function causes the discharged
into a
6
air to be distributed from left to right.
To deactivate the oscillation function, press the
oscillation button
4.6 Timer function
The timer is used to switch off the unit automatically
after a preset time. The timer function can be set in
hourly intervals of up to 8h.
During operation, press the
the timer function. The hour indicator lights up.
Press the button
hour you want.
is unplugged in the me-
6
5 .
3 to switch the
3 again.
4 key to enter
4 repeatedly to set the
Publicité
