Operation; Stand Alone Operation; Dmx-Controlled Operation; Addressing - Futurelight DJ-SCAN 575 Mode D'emploi

If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the DJ-SCAN 575 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the DJ-SCAN 575 can be used without controller. You can do without a controller
as the DJ-SCAN 575 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 575 from the controller and select the desired "Master Mode".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the light
output (control channel 6, DMX-value 250-255).

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the DJ-SCAN 575 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each DJ-SCAN 575
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-SCAN 575 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all DJ-SCAN 575, you may now start operating these via your lighting controller.
Note:
After switching on, the DJ-SCAN 575 will automatically detect whether DMX 512 data is received or not. If
the data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED
lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the DJ-SCAN
575.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
30/64 DJ_SCAN_575_V_1_0