Publicité
OPERATION INSTRUCTIONS
ICONS
Heating Button
Short press the heating button, the heater will recycle between High、Low、Eco and the
digital display will show H2、H1、20°C（68°F）correspondingly.
Once the power is off, the heating elements will stop working first. The fan will continue to
work
for up to 60 seconds to blow out residual heat from inside the heater.
When ECO mode is chosen, the heater will operate to maintain a constant warm 20°C（
Heating
68°F）.
Button
The mode can only be switched by short pressing the "heating button", the "adjustment
button" can only set the temperature, and in ECO mode, the temperature cannot be set.
After setting the mode, short pressing the adjustment button can cycle through 14
temperature settings as following: 22°C, 23°C, 24°C, 25°C, 26°C, 27°C,
ON,15°C,16°C,17°C,18°C, 19°C, 20°C, 21°C (72°F, 74°F, 76°F, 78°F, 80°F, 82°F,ON,
58°F,60°F,62°F,64°F, 66°F, 68°F, 70°F).
'ON' represents the heater is constantly in the heating state
Press and hold the heating button for 5 seconds to toggle between °C/°F.
Flame Button
Default color: red
Short press the button to enter the flame color setting interface, and then short press the
Flame button or Adjusting button, the color will recycle as following: 1. Red; 2. yellow; 3.
Blue; 4. Orange; 5. red and yellow; 6. red and blue; 7. yellow and orange; 8. yellow and
blue; 9. yellow and orange and blue; 10. blue and orange and red; 11. Blue and Yellow
Flame
and Red; 12. Blue and Yellow and Red and Orange
Button
Press and hold the Flame button for 5 seconds to set the speeds of flame, the speeds will
recycle as following: U5-U4-U3-U2-U1, U5 is the fastest. If there is no operation for 10
seconds, the display will switch from the time value to the ambient temperature.
Power Button
When powered on, the power indicator light on the control panel is red, and the digital tube
and other lights are off.
Short press the power button to turn on the heater, the digital display shows room
temperature (default ：℉), and all other button lights are on (white). After 15 seconds of
Power
inactivity on the control panel, the button light and digital tube will turn off. Touch again to
Button
wake up them, and the second touch is effective. Short press the power button again to
turn off the heater, The fan will continue to work for up to 60 seconds to blow out residual
heat from inside the heater.
Note: When turn off and restart the heater, it will remember the data status from the previous shutdown,
including light brightness, color, speed, and temperature compensation values .
After power off, all settings return to default settings.
FUNCTIONS
11
Publicité
