Télécharger Imprimer la page

Technics SC-CX700 Manuel D'utilisation page 9

Masquer les pouces Voir aussi pour SC-CX700:

Publicité

This unit (front)
Primary
01 Speaker unit (Coaxial 2-way unit)
02 Bass reflex port
03 Power indicator
• Blue: The unit is on.
• Off: The unit is in standby mode.
• The power indicator of the primary speaker
blinks when operating this unit with the
remote control or the "Technics Audio
Center" app.
04 Remote control signal sensor
• Reception distance:
Within approx. 7 m directly in front
• Reception angle:
Approx. 30° left and right
05 LED indicators
The LED indicators on this unit light up
in the following manner to indicate the
current status.
Off
Blinking
• If an abnormality occurs, all the LED
indicators on the top of this unit blink 3
times quickly and then repeat. Press [
on this unit to turn it on/off. If the problem
persists, disconnect the AC power supply
cord, wait for at least 3 minutes, and then
reconnect it. Refer to "Troubleshooting" in
On
Softly flickering
]
Control reference guide
Secondary
the "Owner's Manual" (PDF format)
( 04) for details.
06 Touch switch
• Each time you touch the switch, a beep is
heard and the input source changes.
• You can turn the beep sound on/off from
the "Technics Audio Center" app.
07 Standby/on button (
• Press to switch the unit from on to standby
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
08 Mute button (MUTE)
• Press again to cancel. Muting is also
cancelled when you adjust the volume or
when you turn the unit to standby.
• While muted, the LED indicator on the top
of this unit blinks at the current volume
level, and the power indicator on the front
of this unit also blinks.
09 Built-in microphone (for measurement)
10 Volume control buttons (-/+)
• When turning on this unit or adjusting the
volume, the 7 LED indicators on the top of
this unit light up to show the approximate
current volume.
- The LED indicators increase from left to
right as the volume increases.
- The number of lit LED indicators may not
change even when adjusting the volume.
- The volume value can be confirmed using
the "Technics Audio Center" app.
• The LED indicators blink while muted.
)
09
(09)

Publicité

loading