Technics SC-CX700 Manuel D'utilisation page 12

Connections
Basic
Speaker settings
Speaker Assignments (L/R)
(Left/Right)
You can assign each of the two speakers
to either the left or right according to your
installation environment.
• When switching the assignment (L/R) of
primary speaker, the secondary speaker is
automatically assigned to the opposite channel.
• After changing the speaker assignment (L/R),
turn this unit off and then on again.
12
(12)
Speaker connection
When you connect the AC power supply cords
to the primary and secondary speakers and turn
them on, the speakers automatically connect
wirelessly. Once the connection is established,
the power indicators on the front of both
speakers light up.
Note
• If the connection fails, the power indicator
on the front of this unit blinks every 3 times,
repeating every 3 seconds. Turn this unit off
and on to reconnect the speakers.
And you can also connect by pressing and
holding P/S CONNECT button on back of the
primary speaker for 2 seconds. (All the LED
indicators on the top of this unit blink.)
• If the speakers still cannot connect, disconnect
the AC power supply cords from both speakers,
wait for 30 seconds, then reconnect the AC
power supply cords and turn them on.
• For higher sound quality
is unstable causing noise or interrupting
sound on the secondary speaker, use a wired
connection with the supplied speaker link
cable.
Speaker Link cable
(supplied)
* : The maximum sampling rate is 192 kHz /
24 bit for a wired connection and 96 kHz /
24 bit for a wireless connection.
*
or if the connection