Technics SC-CX700 Manuel D'utilisation page 15

AC power supply cords
connection
Connect only after all other connections are
completed.
AC IN terminal
supply cords
To a household AC outlet
• Use only the supplied AC power supply cords.
• Insert the plugs of the cables to be connected
all the way in.
• Do not bend cables at sharp angles.
• Wireless LAN (Wi-Fi
) setting may start when
®
this unit is turned on for the first time, and
the LED indicator (NET) on the top of this unit
blinks. ( 17)
- If you stop the Wi-Fi setting, switch the input
source by pressing the touch switch on the
top of this unit.
- If Wi-Fi setting is enabled, the LED indicator
(NET) on the top of this unit blinks each
time this unit is turned on. If you do not use
the network function, pressing and holding
[NET] on the remote disables Wi-Fi setting
and this unit switches to the previously
selected input source when turning on.
• The LED indicator (NET) does not blink when a
LAN cable is connected. ( 17)
• All the LED indicators on the top of this unit
softly flicker for several seconds during the
power operation. When turning on this
unit, the LED indicators slowly flicker before
showing the current volume level. (If the
network connection is not established, the LED
indicator (NET) on the top of this unit blinks.)
AC power
(supplied)
Note
• When this unit is turned on, the power
indicator of the primary speaker lights up first,
and when this unit is turned off, the power
indicator of the secondary speaker turns off
first.
• This unit consumes a small amount of AC
power ( 22) even when the unit is in standby
mode. Remove the plug from the main
electrical outlet if you will not be using the unit
for an extended period of time. Place the unit
so the plug can be easily removed.
Basic
15
(15)