Publicité
5
QUALITY OF CUT
5.1
QUALITY OF CUT TROUBLESHOOTING _______________________________________
It is recommended that a "test cut" be performed to evaluate
the mower's performance before beginning repairs.
An area should be available where "test cuts" can be made.
This area should provide known and consistent turf
conditions to allow accurate evaluation of the mower's
performance.
Another "test cut" should be performed after the completion
of the repairs and/or adjustments to verify the mower's
performance.
5.2
WASHBOARDING__________________________________________________________
NOTE: Arrow indicates direction of travel.
Probable Cause
Decks have too much or too little weight on them.
Before performing a "test cut" to diagnose cut appearance
and mower performance, the following items should be
verified to ensure an accurate "test cut."
1. Mowing (Ground) Speed
2. Blade Sharpness
3. Height-of-Cut (HOC)
4. Decks Leveled
5. Blade Speed
6. Deck Rake not Set
Washboarding is a cyclical pattern of varying cutting
heights, resulting in a wave-like cut appearance.
This condition is usually caused by the weight transfer not
set correctly.
Washboarding may also be caused by variations in the turf.
TN0159
Adjust weight transfer valve to put more weight on decks.
(Refer to Parts & Maintenance Manual.)
QUALITY OF CUT 5
Remedy
en-25
Publicité
