Publicité
4. Plug the USB wall adapter into a power outlet for charging.
EN
Charging starts automatically. Check the program indicator
lights
8
One indicator light = 25 % charged
Two indicator lights = 50 % charged
Three indicator lights = 75 % charged
Four indicator lights = fully charged
5. When charging is done, unplug the USB wall adapter from the
power outlet and disconnect the USB cable from the charging
port of the remote control.
8 Assembly
Follow the illustrations to assemble the elastic straps (see Fig. C).
1. Open the hook-and-loop fasteners on the elastic straps
2. Guide the small elastic straps
openings and the large elastic straps
openings of the face mask
3. Close the hook-and-loop fasteners to secure the elastic straps
on the face mask.
9 Sensitization test
Before carrying out your first treatment you must carry out a
sensitization test. Follow the steps below:
1. Place the product over your inner arm.
2. Switch ON the product and allow the product to run for its
full 10-minute treatment program.
3. At any time if your skin feels hot or uncomfortable, stop using
the product immediately.
4. After the treatment, wait at least 6 hours. If the skin on your
inner arm appears red and/or itchy, then the product is not
suitable for you. Return the product to the retailer within
14 days of purchase.
17
for the charging progress:
through the small top
4
through the large side
3
.
1
/
.
3
4
Publicité
