Publicité
This treadmill can accept various media medium : USB / MP3 wire / headset socket.
When you are playing music,please make sure the treadmill is in louder state, not
"MUTE" state.
A. USB disk display:
Insert USB disk with music, the system will play them automatically.
Press buttons to choose the music or adjust the volume as you like.
B. MP3 wire display:
Insert the MP3 wire into your audio device (MP3 / PHONE) to display the music.
Press buttons to choose the music or adjust the volume as you like.
C. Headset socket.
Insert headset socket into the hole on the computer to listen to the voice.
ATTENTION
When youplay USB / MP3 all together, the priority level is as below:
1, MP3 wire
2, USB disk.
13. POWER SAVING MODE
This system includes power saving mode, When the treadmill is not running, If there is no button instruction for 10
minutes. The system will enter power saving mode and close the display. Press any button can awaken system.
14. SAFETY LOCK FUNCTION
The window shows"SAFETY KEY PROTECTION" when take away the safety lock and the
treadmill will stop quickly with "BiBi" alarm noise. And put the safety lock on, set program
default.
Maintenance and Malfunction Treatment
1) The surface of the treadmill should be kept clean, pull out the power line
before cleaning. You can clean the running belt and the surface of the treadmill
with a soft and wet cloth.
2) The running belt is adjusted at factory; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting, pull the belt in
the center, and then adjust the left and right bolts in rear roller with hex
spanner (See figure ) it is better to adjust 1/2 circle once. Then turn on the
switch,
check
if
the
belt
10 runs defectively when the running speed is 4~5 km/h.
3) After using over 100hours or the lubricant between the running board and
the running belt is used up, please lubricate the running board and adjust the
running belt well.
4) After a long time of running, the belt may be longer and stuck. You should
turn the left and right adjustor bolt in rear roller clockwise at same position till the runs smoothly and freely.
Warning:
1) The safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g. pins,
connection points.
2) Please replace defective components immediately and/or keep the equipment out of use until repair.
Publicité
