Publicité
• Use rubber gloves to protect hands. Carefully read the safety instructions on
the container of the ice machine cleaner.
8.
Open the water faucet of the main water supply and let the water flow
back into the unit. Again, press and hold the "TIMER CLEAN" button on the
control panel for at least 5 seconds to enter the self-cleaning program.
During this process, the "CLEAN" light will always be on, and the digit
window will indicate the remaining time. Through this process, the water-
dividing pipe, evaporator, water pump, silicone pipe, water tank, etc. will
all be rinsed with clean water to ensure no cleaning solution is left in your
unit.
9.
After one self-cleaning program is complete, remove the drainpipe from
the water tank, drain the wastewater down to the lower ice storage bin,
and shake the unit slightly to drain the water completely. Then, reinstall
the drainpipe to the water tank slot tightly.
10. Repeat steps 8-9 twice.
11. Follow the above program to clean the ice storage bin.
12. When this cleaning program is finished, you can return to the unit to its
regular ice-making mode. Discarding the first batch of ice made after
cleaning is recommended.
CLEANING SUGGESTION
DAILY CLEANING
The ice shovel and door should be cleaned each day. At the end of every day,
rinse the ice shovel and wipe both sides of the door with a clean cloth.
SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate, and the surface
of the evaporator are to be cleaned semi-monthly according to the interior
cleaning program described above.
SEMI-ANNUAL CLEANING
All components and surfaces exposed to water or ice cubes, like the ice storage
bin, water tank, door, evaporator, water pump, silicone tube, water-dividing
pipe, etc. should be cleaned using Nu-Calgon Nickle Safe Ice-machine Cleaner
every 6 months. They should be cleaned by a service person according to the
ice-making assembly system cleaning program.
www.newair.com
EN
31
Publicité
