Publicité
ASSEMBLY & INSTALLATION
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packaging.
• Before plugging in the fridge, let it stand upright for approximately 24
hours. Doing this will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door if it is not already attached (see detailed
instructions below).
INSTALLING THE ICE MAKER
This ice maker is designed to be either built-in or freestanding.
Note: This appliance may be used for the storage of medicine and other
medical products.
Place your ice maker on a floor that is strong enough to support it when it is
fully loaded. To level the unit, adjust the front leveling legs or the screws on the
wheels.
WARNING: Ensure that the air vent at the front of the appliance is never
covered or blocked in any way.
Note: It is recommended that you do not install the appliance near an oven,
radiator, or other heating source. Any nearby heat sources may increase
electrical consumption. Do not install in a location where the temperature will
fall below 50°F (~10°C) or above 110°F (~43°C). For best performance, do not
install the ice maker behind a cabinet door or block the front vent.
Avoid installing the ice maker anywhere with excessive moisture.
Plug the ice maker into a properly grounded wall outlet. Do not plug the ice
maker into a power strip or extension cord.
www.newair.com
EN
15
Publicité
