Télécharger Imprimer la page

NewAir NCI080SS00 Manuel De L'utilisateur page 17

Publicité

EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly
recommended that you do not use an extension cord with this appliance. If you
must use an extension cord, it is absolutely necessary that it be a UL/CUL-listed,
3-wire grounding extension cord with a grounding plug and outlet. The
electrical rating of the cord should be 110 volts.
INSTALLING THE STAINLESS STEEL DOOR HANDLE
To install the door handle, follow the instructions below:
1.
Remove the rubber gasket from the right side of the inside of the door.
(You do not need to remove the whole gasket. Simply remove the side that
covers the screw holes).
2. Remove the screws from the bag included with the unit assembly. Feed the
screws through the holes from the inside until they poke through to the
outer front of the door.
3.
Align the handle with the two screws with hex wrench, then tighten the 2
screws into the handle using a screwdriver until the handle is both flush
and secured tightly against the door frame. DO NOT over-tighten the
screws, as this may cause damage to the door frame.
www.newair.com
EN
17

Publicité

loading