Publicité
WARNING: DO NOT use solvent cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes or damage or discolor the
interior.
STEPS FOR CLEANING THE ICE-MAKING PARTS
During use, periodically clean the main system of your ice maker
1.
Repeat the above steps to clean the water tank and other inner parts of
the unit.
2.
Pay special attention to the water-dividing pipe on the evaporator. When
the compressor and water pump are running normally, water should flow
out through the water-dividing pipe. If there is no water flowing out from
the pipe, or if the flow is very minimal, please remove the water-dividing
pipe to clean carefully. Clean each small hole on the water-dividing pipe as
displayed in the following illustration. Ensure none of the holes are
clogged, then install back to its original location.
3.
When there are ice cubes on the surface of the evaporator that are not
easily falling into the ice storage compartment, do not use any items to
remove the ice by force. Instead, press and hold the "ON/OFF" button for
at least 5 seconds to prompt the unit to enter the ice-melting process.
After some while, the stuck ice cubes will fall down. Then, turn off the unit
and unplug the power cord to clean the surface of the evaporator.
www.newair.com
EN
28
Publicité
