Publicité
REVERSING THE GUIDE BAR
1. Remove the guide bar and chain from
the pole saw following the section:
"REPLACING THE BAR AND CHAIN".
2. Remove the chain from the guide bar
and turn the guide bar over (Fig. 18). The
bottom of the bar will be on the top.
3. Replace the chain on the bar.
4. Reassemble the guide bar and chain on
the pole saw and adjust the chain tension,
following the sections: "REPLACING THE
BAR AND CHAIN" and "ADJUSTING THE
CHAIN TENSION".
TRANSPORTATION
1. Switch the product off and remove the battery pack.
2. Clean the product.
3. Attach the chain sheath on the guide bar and chain.
4. Always carry the product by its handle.
5. Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
6. Secure the product to prevent it from slipping or falling over.
STORAGE
1. Switch the product off and remove the battery pack.
2. Clean the product.
3. Attach the chain sheath on the guide bar and chain.
4. Clean the product and empty the oil tank.
5. Store the product and its accessories in a dark, dry, frost-free, well-ventilated place.
6. Always store the product in a place that is inaccessible to children. The ideal storage is
below room temperature.
7. Keep away from corrosive agents such as garden chemicals and de-icing salts.
SERVICE
We recommend that all tool service be performed by a SKIL Factory Service Center or
Authorized SKIL Service Station.
24
Fig . 18
Publicité
