Publicité
MAINTENANCE
WARNING
battery-operated appliance with the battery pack inserted is always on and can start accidently.
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
CLEANING
WARNING
WARNING
Chemicals can damage, weaken, or destroy plastic, which may result in serious personal
injury.
After each use, clean debris from the chain and guide bar with a soft brush. Wipe the pole saw
surface with a clean cloth moistened with a mild soap solution.
Remove the side cover, and then use a soft brush to remove debris from the guide bar, saw
chain, sprocket and side cover.
Always clean out wood chips, saw dust, and dirt from the guide bar groove when replacing the
saw chain.
REPLACING THE BAR AND
CHAIN
WARNING
that the battery pack is removed .
heed this warning could result in serious
personal injury.
WARNING
chain .
These components are sharp and may
contain burrs.
WARNING
running .
The saw chain is very sharp.
When replacing the guide bar and chain, always use the specified bar and chain
NOTICE
combination listed in the section: "RECOMMENDED BAR AND CHAIN".
1. Remove the battery, allow the saw to cool. Make sure the oil-tank cap is snag to prevent
oil leakage.
2. Position the pole saw on its side on a firm, flat surface, so that the side cover is facing
upwards.
3. Wear gloves. Remove the side cover by loosening the side-cover nut counterclockwise
using the included multi-function wrench (Fig. 8). Clean the side cover with a dry cloth.
4. Remove the worn bar and chain from the mounting surface.
To avoid serious personal injury, remove the battery pack from the
pole saw before inspecting, cleaning, or performing maintenance .
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
When cleaning the pole saw, DO NOT immerse it in water or other
liquids .
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc ., come in contact with plastic parts .
Before performing any
maintenance, make sure
Failure to
Always wear gloves when
handling the bar and
Never touch or adjust the
chain while the motor is
Fig . 8
A
19
Publicité
