Publicité
1b) Operation with cigarette lighter socket
Insert the "L" plug of the cigarette lighter cable into the
DC plug of the device.
2. Insert the nozzle (B2.2) into the upper part (B2.3) by pressing as indicated by the 2 arrows in the 'Con-
nection diagram' in point B2. Insert the Speed selector with valve (B2.4) into the upper part (B2.3) as
shown in the 'Connection diagram' in point B2. Add the medicine prescribed by the doctor into the
lower part (B2.1). Close the nebuliser by turning the upper part (B2.3) clockwise.
3. Connect the accessories as shown in the 'Connection Diagram' on the cover.
4. Sit comfortably while holding the nebuliser in your hand, place the mouthpiece to your mouth or use
a nasal piece (if provided) or mask. If you use the mask accessory,
place it on your face as shown in the figure (with or without the use
of the elastic band).
5. Start up the device by operating the switch (A1) the LED will light
up blue. Breathe deeply in and out; it is recommended to hold your
breath for a moment so that the inhaled aerosol droplets can set-
tle. Then exhale slowly.
6. When the application is finished, switch off the device and discon-
nect it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture forms inside the tube (B1),
detach the tube from the nebuliser and dry it with the ventilation of the compressor itself; this action
prevents possible mould growth inside the tube.
To facilitate the connection of the connection tube (B1) to the compressor unit, act on the end of it by
simultaneously rotating and inserting it, and for removal by rotating and extracting it.
WAYS OF USING THE 'RF7 DUAL SPEED PLUS' NEBULISER WITH SPEED SELECTOR AND VALVE
SYSTEM
It is professional, fast and suitable for the administration of all types of drugs,
including the most expensive ones, even in patients with chronic diseases. Thanks
to the geometries of the internal ducts of the RF7 Dual Speed Plus nebuliser, a
suitable and active particle size was obtained for treatment down to the lower
respiratory tract.
To speed up inhalation therapy, position the speed selector with valve (B2.4) by
pressing the MAX marking with your finger.
To make the inhalation therapy more effective, position the speed selector with
valve (B2.4) by pressing with a finger on the side opposite the Max marking, in this
case you will obtain an optimal administration of the drug while minimising its
dispersion in the surrounding environment, thanks to the valve system with which
the ampoule, mouthpiece and mask are equipped.
Insert the plug of the cable (A9) into the 12V DC
12V
cigarette lighter socket of the car/camper/boat.
Check the vehicle's operating manual to ensure
that the voltage supplied is 12V DC.
27
MAX
Publicité
