Select Modes; Adjusting The Volume; Mute Sound - Krüger & Matz KM1808 Mode D'emploi

Manual setting of the clock
1. In STANDBy mode, press and hold cLOck until "cLOck SET" scrolls on the
display.
2. Press the /
flashing, then press the CLOCK or ENTER button on the remote control to
confirm, then the minute digits will flash.
3. Press the / buttons on the remote control to adjust the minute digits while
flashing, then press the CLOCK or ENTER button on the remote control to
confirm.
Note:
• Press the button on the unit or the
12/24 hour format.
• Each activated state will be cleared if any buttons are not pressed within 15
seconds.
SELECT THE CORRECT TV SYSTEM
change this setting if the video is not displayed correctly. By default, this setting
matches the most common setting for TVs.
1. Press the SETUP button to access or exit system setup menu.
Press the / ,
2. Select [ video ] -> [TV SySTEM].
3. Select setting:
• [PAL] - For TV with PAL color system.
• [AUTO] - For TV that is compatible with both PAL and NTSc.
• [NTSc] - For TV with NTSc color system.

SELECT MODES

Press the button on the unit or the SOURcE button on the remote control
repeatedly to select DISc, USB, OPTIcAL, FM, DAB, Bluetooth, AUX, cOAXIAL, ARc
mode. The selected mode will show on the display.

Adjusting the Volume

To increase or decrease the volume, rotate the VOLUME control knob on the unit or
press the VOL+/VOL- buttons on the remote control.

Mute sound

During play, press the MUTE
rotate the volume knob to unmute.
36
buttons on the remote control to adjust the hour digits while
/ buttons and press the ENTER button to confirm selection.
button to mute. Press the MUTE
button on the remote control to select
Owner's manual
button again or