Fm Radio Operation; Tuning In A Station - Krüger & Matz KM1808 Mode D'emploi

Owner's manual
• Error in signal
A number showing the error rate. If the number is 0, it means the signal
received is error free and the signal strength is strong. If the error rate is high, it
is recommended to reorient the radio aerial or reposition the unit.
• Audio mode
Stereo/Mono
• clock (if not available, the display will show incorrect time)
• Date (if not available, the display will show incorrect date)

FM RADIO OPERATION

Note:
• Before operating the radio, please check that the antenna is correctly connected
and adjusted for length and direction.
• you can program a maximum of 20 FM radio stations
Auto Scan and Save Preset Station
1. Press the button on the unit or the SOURcE button on the remote control
repeatedly to select TUNER mode.
2. Press and hold the PROG button on the remote control to activate automatic
programming. All available stations are programmed in the order of waveband
reception strength.
• The first programmed radio station is played automatically.
• Tune to a Preset Radio Station
• Press the PRESET

Tuning in a Station

• Tune in radio stations automatically
• Press and hold the
or up automatically until a station is found.
• The search may not stop at a station with a very weak signal.
• Tune in radio stations manually
• Press the
• If reception is still poor, try to adjust the position of the aerial or try to move
the radio to another location.
Presetting Stations Manually
you can preset up to 20 FM stations.
1. Tune in the desired station, then press the PROG button.
2. Press the / or number (0~9) buttons to select the preset number.
3. Press the PROG button to store the station.
4. Repeat above steps 1 to 3 for each station you want to store in memory with a
preset number.
/
buttons to select a preset number that you want.
, buttons on the unit, the frequency changes down
, buttons repeatedly until you find the station you want.
39