Citizen CH-453 Manuel D'instructions page 23

BEFORE REQUESTING REPAIRS OR TESTING
Make sure to check the following before sending your blood pressure monitor away
to be tested or repaired.
Display stays blank when
you press the "START/
STOP" switch.
No measurements can
be taken.
Your blood pressure readings are abnormally high or
low compared with those taken in hospital.
Other phenomena
00̲CH453̲ACN̲all.indb Eng-23 00̲CH453̲ACN̲all.indb Eng-23
Problem
Check whether the
batteries are dead.
Check whether the
batteries are installed the
right way round (
oriented correctly).
Check whether the
measurement icon
displayed.
Check whether the cuff is
attached correctly.
Did you stay calm during
measurement?
Note that blood pressure measurement may not be
possible for someone with an extremely weak pulse
or cardiac arrhythmia (irregular pulse).
Checks
Replace all the batteries
with new ones.
Load the batteries in the
correct direction.
and
Attach the cuff properly.
is
Measure your blood
pressure again, making
sure to remain still.
Remove the batteries from
the unit and change them
with new ones.
- -
Eng 23
Response
See page 22.
2012/09/19 10:57:27 2012/09/19 10:57:27