Télécharger Imprimer la page

GYS GALAXY 400T DUO Mode D'emploi page 34

Publicité

User manual
ADJUSTING THE ARC FORCE
It is advisable to set the Arc Force to the middle position (0) to start welding and then adjust it according to the results obtained and individual welding
preferences. Note: The adjustment range of the Arc Force is specific to the type of electrode chosen.
ROLLERS (B) OPTIONAL
Diameter
Steel
ø 0.6/0.8
042353
ø 0.8/1.0
042360
ø 1.0/1.2
046849
SEPARATE WIRE FEEDER WF 36
It is not possible to use 2 MIG/MAG torches at the same time. When one reel is activated, the other is inactive.
HMI - wire feeder active
DEFECTS: CAUSES & SOLUTIONS
SYMPTOMS
The flow rate of the welding wire is not
constant.
The unwinding mechanism is not working.
34
Translation of the original
instructions
Reference (x2)
Aluminum
-
042377
040915
The 400T DUO product can be fitted with a separate WF 36 wire feeder (option, ref. 082502) in order
to quickly use 2 different wire types or diameters without changing torches or spools. The connection
between these two parts is made through a dedicated cable link, available separately:
Type of torch cooling
Air
Water
For connecting the interconnection between the power source and the wire feeder, refer to the wire feeder
manual.
HMI - wire feeder inactive
Clogs blocking the opening.
The wire is slipping on the rollers.
One of the rollers is spinning.
The torch cable is twisted.
The spool's brake or roller is too tight.
Reference (x2)
Diameter
Flux-cored wire
ø 0.9/1.2
042407
Length
Section
5 m
70 mm²
70 mm²
10 m
95 mm²
15 m
95 mm²
20 m
95 mm²
1.8 m
70 mm²
5 m
70 mm²
70 mm²
10 m
95 mm²
15 m
95 mm²
20 m
95 mm²
To switch from an inactive wire feeder to an active wire
feeder, press the trigger on the non-active torch or
press the thumbwheel on the non-active display.
POSSIBLE CAUSES
GALAXY 400T DUO / 400T W
Reference
075443
075450
077553
082083
082090
To ensure optimum
075467
welding in Pulse mode,
075474
it is recommended not to
exceed 10 m beam length.
075481
075504
079816
082106
SOLUTIONS
Clean the contact tube or replace it with non-
stick material.
Reapply the non-stick product.
Check the tightness of the roller screw.
The torch cable should be as straight as
possible.
Loosen the brake and rollers.

Publicité

loading

Ce manuel est également adapté pour:

Galaxy 400t w