Publicité
ENGLISH
Additional
Information
Disc Care
How to hold discs
When loading or removing discs,
try not to touch their playing
surfaces.
Cleaning
Fingerprints or other dirt on the disc may affect sound and
picture quality.
To clean your discs, use a soft clean cloth to wipe them. If
necessary, moisten a soft cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
Do not wipe in a circular
direction (Concentric
scratches in the disc groove
tend to cause noise.)
Discs must not be cleaned with record cleaning sprays, or
static prevention sprays, etc. Also do not use volatile liquids
such as benzine, or thinner, etc.
Lens cleaner
The player's pickup lens should not become dirty in normal
use, but if for some reason it should malfunction due to
soiling, contact your nearest MARANTZ service center. Lens
cleaners are commercially available, but special care should
be exercised in their use since some may cause damage to
the lens.
Never play cracked or warped discs
The disc revolves in the player at high
speed when it is played. Never play a
cracked, scratched or warped disc. This
may damage the player or cause it to
malfunction.
Never use discs with special shapes
CD's with special shapes (heart-shaped
CDs, octagonal CDs, etc.) cannot be
played on this set.
Attempting to do so may damage the set.
Do not use such CDs.
48
Gently wipe from the
inside toward the outer
edge.
After using discs, store them upright
After playing a disc, always remove it from the player and
return it to its jacket. Then store it standing upright away from
heat and humidity.
• Store discs carefully. If you store discs at an angle, or
stacked on top of each other, discs may become warped
even when in their jackets.
• Do not leave discs in locations such as the seat of a car,
which may become excessively hot.
CAUTION WHEN USING THE DISC
All rights reserved.
Unauthorized public performance, broadcasting or
copying is a violation of applicable laws.
Notes on using optical cables
• Do not route cords around sharp angles.
When storing, wind the cords so that they
have a diameter of at least 15 cm (6 in.).
• When connecting, push all the way into the
terminal.
• Do not use cords with a length of over 3 m.
• If moisture or dust has collected on the
plug, wipe it with a soft cloth before connecting.
15 cm (6 in.) dia.
or more
Publicité
