Télécharger Imprimer la page

Kinetec dr.aktive CRYO PRO Manuel D'utilisation page 4

Publicité

(5) OPERATING THE SYSTEM
1. Push the lid release button to open the cooler lid (1), add
water to fill-line indicated on label within the cooler (2).
ENSURE WATER IS ABOVE THE FILL-LINE. Add as much ice as
you want but do not exceed the ice max mark (3). After ice is
added close the lid (4).
2. Apply
the
selected
DO NOT APPLY DIRECTLY TO SKIN. Add an isolation layer
between the cuff and the skin (pyjamas, jogging bottoms).
3. Connect cuff to cooler using connector hose. For best results,
place the cooler at the same level as the cuff. The height
difference between the two should not be more than 40cm.
4. Connect the AC adaptor to the cooler (12), then plug the AC
adaptor (13).
5. Press the
button for about 3-5 seconds, the screen should
light up and show Welcome.
6. Press the
or
button to choose the mode/pressure.
Mode
Pressure
1
2
Low
3
4
5
Mid
6
7
8
High
9
Mode: There are 9 modes. Shows which program you have
selected.
Pressure: There are 3 levels: low, medium, high. Represents the
pressure of cuff against the cooler during operation.
Time on: Time of active cold compression.
Time off: Pause time between compression cycles.
cuff
(knee
cuff
as
Time on (min)
Time off (min)
20
40
60
20
40
60
20
40
60
7. Press the
When cooling you can press the
8. Press the
cooler.
example).
9. After use, to drain the cuff, disconnect the cuff from the
cooler. Connect to the cuff the drain gadget. Once the drain
gadget is connected squeeze the cuff to push the water out
through the drain gadget (14).
To drain the cooler, remove the lid and pour out the ice and
water. Alternatively, you can use the drain gadget (15).
• Clean the surface of the cooler by wiping using a soft and damp
cloth.
• Carefully dry the cuff with a dry cloth before storage to prevent
from moisture.
• The product should be stored in a cool, dry, well ventilated and
clean environment without corrosive substance.
20
40
60
20
40
60
20
40
60
EN
button to start or pause the cooler.
button to pause.
button for about 3-5 seconds to turn off the
(6) CLEANING AND STORAGE

Publicité

loading